• December 01. 2022

What Are Rogers Materials? We shall start this section of the article with defining the Rogers PCB materials. The primary materials used in Rogers PCBs are high frequency and hydrocarbon ceramics. It supports improved production development and has a significant impact. Additionally, it lowers the cost of the printed construction, which allows for continuous heating. As a result, it lessens the el...

• December 06. 2022

RF-10 laminates are designed to offer a cost-effective substrate with acceptable delivery times for the industry. RF-10 fills a requirement for size reduction in RF applications. This kind of 60mil RF-10 substrate is used to construct low loss, high DK PCBs. With a sizable region of immersion gold and a partial green solder mask, it is a double layer build-up. With a high dielectric constant (10.2...

• December 07. 2022

RF-35 High volume commercial microwave and RF laminate Taconic RF-35 is an organic-ceramic laminate in the ORCER family of Taconic products. lt is based on woven glass reinforcement. RF-35 PCB is a result of Taconic's expertise in both ceramic fill technology and in coated PTFE fiberglass. RF-35 material is the best choice for low cost, high volume commercial microwave and radio frequency applicat...

• December 13. 2022

Teflon PTFE PCB High-frequency PCBs using polytetrafluoroethylene (PTFE) as their PCB substrate are known as Teflon PCBs or PTFE PCBs. Teflon PCBs transmit signals at frequencies up to 5 GHz. Dupont Corporation markets its PTFE materials under the Teflon brand name, which is so well-known that people often refer to PTFE substrate PCBs used in microwave and RF applications as Teflon PCBs. Propertie...

• December 14. 2022

Taconic CER-10 RF PCB Printed Circuit Board CER-10 is an organic-ceramic DK-10 laminate in the ORCER family of Taconic products. It is based on a woven glass reinforcement. CER-10 PCB exhibits exceptional interlaminar bond strength and solder resistance. Its proprietary composition results in low moisture absorption and uniform electrical properties. Taconic CER 10 PCB has a board between each lam...

• December 20. 2022

What's the Features  & Bebefits for TC600 PCB? For use as a printed circuit board substrate, the "Best-In-Class" thermal conductivity of the TC600 woven fiberglass reinforced, ceramic filled, PTFE-based composite is intended to improve heat transmission while lowering insertion and dielectric loss. Greater amplifier and antenna gains/efficiencies are produced via lower losses. For the 6.1...